Notes library · Technical

🔗 Prestressed Concrete Design Notes

Principles and materials of prestressing, pre- and post-tensioning systems, analysis of prestressed sections, losses, flexure and shear design, anchorage zones, PSC girders and slabs, deflection and cracking.

8 of 8 chapters written

Chapters

  1. 01Principles & Materials of PrestressingThe idea of prestressing, the three ways of looking at it (elastic material, high-strength steel–concrete couple, load balancing), the advantages and limits of prestressed concrete, the materials used — high-strength concrete and high-tensile steel wires, strands and bars — their stress–strain behaviour, relaxation, creep and shrinkage, and the basic stress equation.Read →
  2. 02Pre-tensioning, Post-tensioning Systems & AnchoragesHow prestress is applied — pre-tensioning on long-line beds with bond and transfer length, post-tensioning with ducts, jacks and anchorages, the main commercial systems (Freyssinet, Magnel–Blaton, Lee–McCall, strand systems), equipment, grouting, bonded and unbonded tendons, and the anchorage devices that hold the prestress.Read →
  3. 03Analysis of Prestressed SectionsStress analysis of prestressed beams under concentric and eccentric prestress and external load, the kern and the pressure line (C-line), the limiting eccentricity zone (Magnel diagram idea), the load-balancing method with parabolic tendons, and the stages of loading — transfer and service.Read →
  4. 04Losses of PrestressThe immediate and time-dependent losses in pre-tensioned and post-tensioned members — elastic shortening, friction (curvature and wobble), anchorage slip, shrinkage, creep and relaxation — the formulae, typical percentages, worked examples, and how losses affect the effective prestress used in design.Read →
  5. 05Design for Flexure & ShearDesign of prestressed concrete beams — allowable stresses and classes of prestressing, minimum section modulus and prestress at the two stages, ultimate flexural strength, modes of failure and minimum steel, and shear design — shear in uncracked and cracked sections, effect of an inclined tendon, and the design of stirrups.Read →
  6. 06Anchorage Zone & End Block DesignWhat happens where a concentrated prestressing force enters the concrete — the local zone and general zone, bursting, spalling and edge tension, Saint-Venant's principle and the length of the disturbed region, Guyon's formula for bursting tension, reinforcement detailing, bearing pressure under the anchor plate, and strut-and-tie modelling.Read →
  7. 07PSC Girders & SlabsDesign procedure for a prestressed concrete girder — choice of section and depth, prestress and tendon profile, stress checks, shear and end block, deflection and camber, composite girders, continuity and detailing; and prestressed slabs — one-way, two-way and flat slabs, bonded and unbonded tendons, load balancing and span–depth ratios.Read →
  8. 08Deflection & Cracking of Prestressed MembersHow deflection of a prestressed beam is calculated — camber from the tendon, downward deflection from load, net short-term and long-term deflection with creep — the code limits, and how cracking is controlled: cracking moment, classes of prestressing and permitted crack widths, partial prestressing and durability provisions.Read →

Exams that include Prestressed Concrete Design

Open your exam to see only the chapters its syllabus asks for.